Crestron QM-MD8x8 Especificaciones descargar pdf (Pagina 34)

QuickMedia Distribution System Crestron QM-MD8x8

Operation

Operating Modes

The MD8x8 operates in either the system mode or the local mode. When operating in

the system mode, all switching functions are controlled by the control system.

Additionally, signal routing information can be viewed using the front panel controls

of the MD8x8. When operating in the local mode, all switching functions are

controlled by the buttons on the front panel.

Press the SYS button located on the front panel to select the system mode or press

the LOCAL button to select the local mode. The SYS LED will illuminate when the

MD8x8 is operating in the system mode. The LOCAL LED will flash when the

MD8x8 is in the local mode.

NOTE: The local mode may not be available if the buttons on the front panel are

locked by the control system. The LOCAL LED will rapidly flash three times and

turn off to indicate that the local mode is not available when the front panel is

locked.

Viewing Signal Routes in the System Mode

When in the system mode (SYS LED is illuminated), pressing an input signal button

will display all of the outputs that are connected to it. Pressing an output signal

button will display the input signal that it is connected to as well as all of the other

outputs that are receiving the same input signal.

The AUDIO BREAK LED will illuminate if there is any difference between the

audio and video route for any signal. The A and V LEDs indicate which portion of a

signal is displayed. Press A or V to select the portion to display.

NOTE: The AUDIO BREAK button has no function when the MD8x8 is operating

in the system mode.

Switching Signals in the Local Mode

Signals coming in to the MD8x8 can be switched to individual or multiple output

locations. Additionally, the audio and video portions of an input signal can be

switched simultaneously or separately.

Switching Audio & Video Simultaneously:

1. Make sure that the MD8x8 is in the local mode (the LOCAL LED is

flashing slowly).

2. Disable the audio break function. When audio break is disabled, the

AUDIO BREAK LED will be off and the V LED will be on.

NOTE: When disabling the audio break function, routes will switch if needed so

that all audio outputs will have the same input as the corresponding video output.

This means that when an audio output has a different input than its corresponding

video output, the output's selected audio input will change to match the selected

video input.

30 • QuickMedia Distribution System: QM-MD8x8 Operations Guide - DOC. 6260

1 2 ... 29 30 31 32 33 34 35 36 37 38 39 ... 43 44

Sin comentarios

Crestron QM-MD8x8 Especificaciones Pagina 34