Crestron D3 PRO Manual de usuario descargar pdf (Pagina 14)

• No longer allow a Remote System to be added to a processor that does not support

Ethernet (e.g. CP2).

• Fixed bug where programming certain devices (e.g. CLW-DIM1RF) that use the “tree

interface” rather than the Engraver, where the selected item on the tree would lose its

highlighting once it had lost focus.

• Trace dialog will now show entire expressions when the device in question has been

used in a Conditional Step. For example, instead of showing “(GateStatus = On)”, it

will now show “If (Gate Status = On) Then”

• Slight modification to program generation logic to prevent lights flashing off at startup

(requires CLX v1.xxx firmware, not yet released).

• Fixed bug where an apostrophe in a Room name (or device name) would not

properly connected to the logic a Remote System Export.

v1.5.9 (BETA)

• Fixed bug (introduced in v1.5.4) where adding multiple steps at one time (e.g. by

holding down the control key) would not “synchronize” those steps to any other

events on the button. Thus a Toggle might have commands on the “On” press, but no

corresponding commands on the “Off” press.

• Fixed bug where Remote System devices would not work properly if they were added

after a Remote System Import. Major bug!

• Fixed bug where Multipress buttons having a timeout greater than 10 minutes and 55

seconds would cause the program to be generated incorrectly.

• Fixed bug where “Preset” feedback on learnable buttons was incorrect once the

project rebooted (unless the user had saved a new level to the button).

• Modified behavior of “Cancel Global Preset” steps when the Global Preset has been

set to have the “Restore Light Levels” behavior. Now the lights will only be restored if

the preset had previously been “run”.

• Fixed bug where certain “level-triggered” commands would default to having a fixed

pulse-length rather than pulsing for as long as button was held down.

• Fixed bug in Bill Of Materials where CAEN Enclosures and CAEN Accessories would

not always appear properly in the BOM report.

• Fixed bug where CLX-PWS75, CLX-2IND, and CLX-4IND had missing images in the

Enclosure report.

• Fixed bug where .rsd files created by D3 Pro (i.e. for Remote System Export and

Touchpanel Export devices) were not included in the .d3a file when an archive was

created.

• Fixed bug where newly created projects were not added to the File menu’s Most

Recently Used list if you subsequently imported an archive.

• Fixed bug where Cancel button in touchpanel build log did not work

• Set minimum required version of VTPro-e to v3.3.3.5 (was v3.4.1.2, but with updated

templates, v3.3.3.5 works fine).

• Fixed some missing Help button links

• Added the ability to have an interface show the Engraver in Interface View, yet hide it

in Programming View.

• Fixed rare bug where virtual keypads could cause a project not to open (only saw

one reported case of this bug)

• Fixed bug where re-browsing for a new .rsd file in an existing Remote System Import

device would not clear any existing commands, but would simply add the new

commnads to those existing ones.

• Fixed bug where the Trace dialog did not show steps inside of Global Expression

presets.

• Fixed bug where extremely long command names (> 50 characters) used in a step

would not save properly.

• Fixed bug where the “Use Crestron Toolbox for Setup Net ID’s” option was actually

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 23 24

Comentarios a estos manuales

Sin comentarios

Crestron D3 PRO Manual de usuario Pagina 14

Comentarios a estos manuales

Relacionado con productos y manuales para Software Crestron D3 PRO