Crestron CHV-TSTATEX Guía de instalación descargar pdf (Pagina 30)

Thermostats Crestron CHV-TSTAT and CHV-THSTAT

•

Thermostats: CHV-TSTAT and CHV-THSTAT Operations and Installation Guide – DOC. 8163E

Thermostat Setup

Setup Procedure

After the thermostat is installed, it is necessary to set it up for a particular

heating/cooling system. There are nine types of heating and cooling systems. The

available choices displayed on the setup screens depend on the type of system

selected. Follow these directions to access the setup screens.

1. Press and hold the MODE and VIEW buttons simultaneously for 5 seconds

to access the setup menus.

2. Press VIEW to select the parameter. A box appears around the selected

parameter.

3. Press the arrow keys (▲▼) to choose the value of the selected parameter.

4. Use the MODE button to advance to the next setup screen.

CHV-TSTAT and CHV-THSTAT Setup

MODE

VIEW



CRESTRON

Advance to next

selection on current

Setup Screen

Change value

of selected

parameter

Advance to next

Setup Screen

Setup Notes

The following are general setup notes.

NOTE: Refer to “System Connections” on page 10

for remote sensor connections to

the thermostat.

NOTE: The Offset option permits recalibration of the room temperature sensor. The

offset is the number of degrees added to or subtracted from the actual temperature.

The range is -6° to +6° F. Factory default is 0° F. This adjustment changes the actual

regulated temperature, not just the display.

NOTE: The sensors are used for temperature and humidity averaging. Choose USE

to include each sensor, or OMIT to exclude each sensor in the averaging equation.

Sensors that have the same designation (for example, outdoor) are averaged together.

NOTE: The thermostat does not leave Setup mode unless a valid sensor selection is

made.

1 2 ... 25 26 27 28 29 30 31 32 33 34 35 ... 91 92

Sin comentarios

Crestron CHV-TSTATEX Guía de instalación Pagina 30