Crestron CHV-TSTATEX Guía de instalación descargar pdf (Pagina 82)

Thermostats Crestron CHV-TSTAT and CHV-THSTAT

•

Thermostats: CHV-TSTAT and CHV-THSTAT Operations and Installation Guide – DOC. 8163E

Control System Error Log Message Formats

When a remote sensor that has been designated as USE, SLAB, or OD in the Setup

Sensors screen (refer to “Thermostat Setup”, which begins on page 24) generates an

error, a message is sent to the error log. Retrieve this message using the System Info

tool in Crestron Toolbox:

1. Using Crestron Toolbox, select Tools|System Info.

2. Select the control system from the address bar and examine the Error Log.

Error Message Format

Sensor <channel> type <designator> <CHA errors>, <CHB

errors> Errors @ <cycle count>

Where:

channel is the sensor channel string

designator is the sensor setup designation

CHA errors/CHB errors are the number of errors on each sub-channel

cycle count is the number of read cycles that have occurred.

NOTE: Both sub-channels have their error count reported, regardless of the sensors

connected.

This message is sent upon the first error detected on the channel, as well as every

100 errors detected thereafter. When only one sensor is connected to a remote

interface, its values assume the <CHA> position. The values for the <CHB> position

are not used. When two sensors are connected to a remote interface, the <CHA>

position indicates the errors for the first sensor, and the <CHB> position indicates

the errors for the second sensor.

The following is an example output, as seen in Crestron Toolbox, when a single

outdoor sensor connected to RS1 accumulates 101 read failures:

Error: Message from device Slot-09.ID-2A: Sensor R1T

type OD: 101,3922 Errors @ 3922 (0056:0000:0056)

The following is an example output, as seen in Crestron Toolbox, when two air space

sensors are connected to RS1 and the first sensor encountered a read failure:

Error: Message from device Slot-09.ID-2A: Sensor R1T

type USE: 1,0 Errors

@ 5943 (0056:0000:0056)

1 2 ... 77 78 79 80 81 82 83 84 85 86 87 ... 91 92

Sin comentarios

Crestron CHV-TSTATEX Guía de instalación Pagina 82