Crestron Lighting Design Guía de instalación descargar pdf (Pagina 27)

230 V Lighting Design Guide

Doc. 4859C | crestron.com

Double Width Enclosure Mounting

The module and associated terminal block are installed in a double width enclosure. The PAC2 processor occupies

the lowest module position.

Module Bypass Jumpers

CAUTION: A bypass jumper is provided to allow testing and to protect the module during installation. When properly

secured by nine screws, the jumper on the black and red section of the terminal block shorts the line to the output

so that the circuit is energized. Do not remove the bypass jumper until all feed and load wiring has been completed,

the circuit has been tested for electrical faults, and the module has been installed. The jumper on the white section

of the terminal block ties the neutral in to the neutral outs. This jumper should never be removed.

NOTE: Use copper conductors only—rated 75° C.

Cresnet Terminal Block for CAEN Automation Enclosures

The CAEN-BLOCK is a Cresnet terminal block designed speciﬁcally for Crestron lighting and automation systems to

link extension enclosures and satellite enclosures to the central PAC2 or PAC2M control system. The CAEN-BLOCK

mounts at the bottom of each CAEN enclosure that does not contain a control system to provide Cresnet and

Override signal connectivity for CLXI-Series lighting control modules within. The CAEN-BLOCK serves as a parallel

distribution block for multiple Cresnet cables, and provides for connection of the Cresnet and override signal cables

from the central control system.

PAC2 Processor in Double Width Enclosure Mount

1 2 ... 22 23 24 25 26 27 28 29 30 31 32 ... 81 82

Sin comentarios

Crestron Lighting Design Guía de instalación Pagina 27