Crestron CHV-TSTATEX-FCU Guía de instalación descargar pdf (Pagina 13)

Crestron CHV-TSTATEX-FCU infiNET EX Thermostat (Fan Coil Unit)

Operations & Installation Guide – DOC. 7206C infiNET EX Thermostat (Fan Coil Unit): CHV-TSTATEX-FCU

•

Setup

Identity Code

NOTE: The latest software can be downloaded from the Crestron Web site

(www.crestron.com/software).

Every CHV-TSTATEX-FCU communicating via RF with a Crestron control system

through a CEN-RFGW-EX wireless gateway or directly with an MC3 3-Series

Control System requires a unique RF ID. The RF ID is a two-digit hexadecimal

number that can range from 03 to FF. The RF ID of the unit, set using Crestron

Toolbox™, must match the RF ID specified in the Crestron Studio or SIMPL

Windows program.

Supplied Hardware

The hardware supplied with the CHV-TSTATEX-FCU is listed in the following

table.

Supplied Hardware for the CHV-TSTATEX-FCU

DESCRIPTION PART

NUMBER

QUANTITY

Screws, Zinc, Phillips, Pan Head, #06-32 x 1” 2007251 2

Batteries, AA, Alkaline 2001050 2

Installation

NOTE: Installers should have a strong working knowledge of HVAC systems.

The location of the thermostat can affect its performance and efficiency. Install the

thermostat away from direct sunlight, drafts, doorways, skylights and windows. Also

make sure the thermostat is conveniently located for control access and setup.

Thermostats should be mounted 60 inches (~1.6 meters) above the finished floor

(HVAC industry standard). Do not mount on an exterior wall.

The following tools and hardware are required for installation:

• Standard 1-gang electrical box, mounted horizontally (not supplied)

• Phillips screwdriver (not supplied)

• Two 1-inch pan head Phillips screws (included)

• Two AA batteries (included)

Use the following procedure to install the CHV-TSTATEX-FCU in a standard,

1-gang electrical box (refer to illustration on the following page):

1. Turn HVAC system power OFF.

2. Separate thermostat front plate from rear plate. It may be necessary to exert

force when removing the front plate.

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 39 40

Sin comentarios

Crestron CHV-TSTATEX-FCU Guía de instalación Pagina 13