Crestron CHV-TSTATEX-FCU Guía de instalación descargar pdf (Pagina 22)

infiNET EX Thermostat (Fan Coil Unit) Crestron CHV-TSTATEX-FCU

•

infiNET EX Thermostat (Fan Coil Unit): CHV-TSTATEX-FCU Operations & Installation Guide – DOC. 7206C

Advanced Setup

Setup Mode

After the CHV-TSTATEX-FCU is installed, it is necessary to set it up for a

particular heating/cooling system. Please note that some of the setup parameters

listed below are not always shown since they are dependent upon other thermostat

settings. Refer to “Setup Mode Parameters/Functions”, which starts on page 19 for

details.

Place the CHV-TSTATEX-FCU in the Setup mode by doing the following:

1. Press and hold the FAN button.

2. While the FAN button is being held, press and hold the

and buttons

simultaneously.

3. Hold all three buttons for 5 seconds, after which the unit enters Setup mode.

Once in Setup mode, the display indicates the currently selected setup

parameter/function. Press and release the MODE button quickly (it must be released

within one second) to change to the next parameter/function in the list.

NOTE: Holding the MODE button for more than one second resets the currently

selected parameter/function to its default value.

When setting parameters (such as when choosing between Fahrenheit or Celsius

display), pressing the

or button increments or decrements the value. Value

change occurs when button is released.

When a function is selected (such as when starting an infiNET EX acquire), pressing

either

or executes the function.

To exit from Setup mode, press the FAN button on the CHV-TSTATEX-FCU.

CHV-TSTATEX-FCU LCD Display (Setup Mode)

MODE

FAN

Skips to Next Setup

Parameter/Function

Indicates Current Setup

Parameter/Function

Indicates Current Value for

selected Setup Parameter

Exits Setup Mode

Adjust Current Setup

Parameter/Function Value

NOTE: When the CHV-TSTATEX-FCU is in Setup mode the large 7-segment

displays show the current setup parameter/function. The small 7-segment displays

show the current value for the selected setup parameter, if applicable, or it displays

“—” when a function is selected. All other display elements are hidden (refer to

“

LCD Display” which starts on page 26).

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 39 40

Comentarios a estos manuales

Sin comentarios

Crestron CHV-TSTATEX-FCU Guía de instalación Pagina 22

Comentarios a estos manuales

Relacionado con productos y manuales para Termostatos Crestron CHV-TSTATEX-FCU