Crestron CHV-TSTATEX-FCU Guía de instalación descargar pdf (Pagina 23)

Crestron CHV-TSTATEX-FCU infiNET EX Thermostat (Fan Coil Unit)

Operations & Installation Guide – DOC. 7206C infiNET EX Thermostat (Fan Coil Unit): CHV-TSTATEX-FCU

•

NOTE: While in Setup mode, a period of one minute with no button activity causes

the CHV-TSTATEX-FCU to revert to standard operation, unless a function (such as

an infiNET EX acquire) is executing.

Setup Mode Parameters/Functions

The following table shows the available setup parameters/functions.

Setup Mode Parameters/Functions

PARAMETER/

FUNCTION

CODE VALID VALUES

DEFAULT

VALUE

NOTES

Temperature

Scale

FC F, C F Sets units to use for temperature display

(Fahrenheit or Celsius)

Backlight

Timeout

bL 1 – 4 seconds or

disabled (--)

4 seconds Sets the number of seconds the backlight

remains lit after a button press

Auto Dead

Band

db 2 – 6 (for

Fahrenheit)

or 1 – 3 (for

Celsius)

2 Used to set minimum separation between

heat and cool setpoints (with dual

setpoints) or maximum drift before

system latches alternate mode (with

single setpoint)

Heat Setpoint

Limit

HL 50 – 90 80 Sets the highest heat setpoint that is

allowed

Cool Setpoint

Limit

CL 50 – 90 60 Sets the lowest cool setpoint that is

allowed

Temperature

Offset

to -9 to +9 (for

Fahrenheit)

or -5 to +5 (for

Celsius)

0 Permits recalibration of room temperature

sensor;

This is the number of degrees added to

or subtracted from the actual

temperature;

This adjustment changes the actual

regulation temperature, not just the

display

Heat Anticipator HA 1 – 6 3 Lower setting results in more frequent

cycles and faster response (tighter

regulation);

Higher setting results in less frequent

cycles and slower response (looser

regulation);

The default value should suffice in nearly

all installations

Cool Anticipator CA 1 – 6 3 Lower setting results in more frequent

cycles and faster response (tighter

regulation);

Higher setting results in less frequent

cycles and slower response (looser

regulation);

The default value should suffice in nearly

all installations

(Continued on following page)

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 39 40

Comentarios a estos manuales

Sin comentarios

Crestron CHV-TSTATEX-FCU Guía de instalación Pagina 23

Comentarios a estos manuales

Relacionado con productos y manuales para Termostatos Crestron CHV-TSTATEX-FCU